APR MS100106 - Spherical Pendulum Mount - PQ35

APR - MS100106

APR Spherical Pendulum Mount - PQ35

Fits 2005-2019 Audi A3, Q3, TT, TTS, Volkswagen Beetle, CC, Eos, Golf, Golf R, GTI, Jetta, Passat

The APR Pendulum mount replaces the factory mount with a new, thick, billet-aluminum two-piece design, featuring a PTFE-lined spherical bearing and ARP(R) bolts. The system stiffens the driveline to improve shift quality and power transition, while addressing the common and costly factory failure point at the transmission mounting location. It is easy to install, addresses all concerns with the factory setup and includes all necessary hardware to bolt on and enjoy!

• Each piece is anodized black to provide corrosion resistance and the APR logo is laser etched on each side.
• The APR system includes non-one-time-use bolts for their strength, quality and longevity over the factory bolts.
• Easy to install
• Full install directions are included with each system
• The front and rear pieces replace the factory cast aluminum and stamped steel pieces with precisely machined, billet-aluminum pieces that are both lightweight and strong.
• By removing the factory rubber bushing, the APR system reduces slop in the driveline to improve shifts, and transmission of power to the ground.
• The system is easy to install, doesn't require dropping the sub-frame and is compatible with the factory and factory-like modified sub-frame mounts.
• Because of the new design's mounting orientation, the system is far less likely to tear out or break the rear bolts, which typically results in costly repairs or full transmission case replacement.
• Spherical bearing
• Reduces transmission failure
• Replacement Bolts
• The bearing is fully-serviceable, features a heat-treated race and precision-ground ball, with a self-sealing and self-lubricating PTFE lining.
• Spherical bearings offer far less unwanted movement over rubber and polyurethane inserts.
• Expect a sportier feel during acceleration, deceleration and gear changes without an excessive increase in NVH when paired with the factory sub-frame mount.
• As such, the APR mount uses a spherical bearing, made possible by upgrading the rear mounting hardware.
• The factory bolts are one-time-use, and must be replaced when installing a new mount.
• The factory rear mounting point was upgraded to the new MQB / MK7 platform style mount as the older design was prone to failure under heavy use.
• Billet aluminum construction
• Reduces transmission movement